附录:边侧环境(nexinf)
附录1:
- 下载离线安装包
ZIPnexinf-cloud-wheel.zip请联系对接人员获取
下载完整压缩包,解压到用户家目录
bash
unzip ~/nexinf-cloud-wheel.zip编辑配置
编辑路径文件:/home/nexinf-cloud-wheel/nexinf/nexinf/nexinf/config/config.toml
将环境自动推送到机器人本体内
text[basic] robot_type = "mos" # mos | station-lite; 选择整套机器人适配及对应机型配置 [network] robot_ip = "<机器人IP>" # 机器人主机的局域网地址确保笔记本与机器人网络互通
可通过 SSH 登录机器人
bash
ping <机器人IP>bash
ssh nvidia@<机器人IP>bash
ssh lumos@<设备IP>执行安装程序
- 环境安装
执行如下脚本,直到提示 5/5 部署完成
bash./nexinf-cloud-wheel/install.sh- 配置环境变量
每次新开终端,先执行(必须执行)
bashcd ~/nexinf-cloud-wheel source ./nexinf/activate.sh
附录2:
每次新开终端,先执行(必须执行)
bashcd ~/nexinf-cloud-wheel source ./nexinf/activate.sh运行midserver
bashmidserver run #Station-Lite 部署后配置开机自启动 | mos需要手动解锁并运行station设备
bashnexinf-bridge run --station-litemos设备
bashnexinf-bridge run --mos
附录3:
每次新开终端,先执行(必须执行)
bashcd ~/nexinf-cloud-wheel source ./nexinf/activate.sh运行midserver
bashmidserver run #Station-Lite 部署后配置开机自启动 | mos需要手动解锁并运行运行policy
bashnexinf run --policy

